iPhone 14 Pro Max
ƒ/1.78
6.86 mm
1/10,753
80
It actually flies straight, a bowtie design that maxes out the print area of a Makerbot Replicator 2.
Launch photos below, on a Cesaroni K160.
One response to “3D-Printed 4″ Diameter Fin Can”
-
It got a little squirrely on this flight, and the long-burn motor shifted to low thrust
It landed backwards with no ‘chute event, perhaps due to air pressure of retro-entry
The fin can shattered on landing, and the lower blue tube airframe broke in half, an unusual failure mode I have not seen before
Leave a Reply